2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013


REMOVE PTC HEATER RELAY (PTC NO. 1, PTC NO. 2 AND PTC NO. 3)

  1. E283859E01
    Remove the 3 PTC heater relays from the engine room relay block.
    Text in Illustration 
    *1
    PTC NO. 1 Relay
    *2
    PTC NO. 2 Relay
    *3
    PTC NO. 3 Relay


INSPECT PTC HEATER RELAY (PTC NO. 1, PTC NO. 2 AND PTC NO. 3)

A092673E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied between terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    1. If the result is not as specified, replace the relay.


INSTALL PTC HEATER RELAY (PTC NO. 1, PTC NO. 2 AND PTC NO. 3)
  1. Install the 3 PTC heater relays to the engine room relay block.

← ON-VEHICLE INSPECTION (from Aug 2013)COMPONENTS (from Aug 2013) →