2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE RESONATOR WITH AIR CLEANER CAP SUB-ASSEMBLY

  1. A224304
    Disconnect the sensor connector.

  1. Detach the wire harness clamp.

  1. Loosen the hose clamp and remove the resonator with air cleaner cap.

  1. A226728
    Detach the 4 hook clamps, and then remove the air cleaner cap and resonator with air cleaner cap.


2. REMOVE INTAKE PIPE

  1. A223437
    Remove the 2 bolts.

  1. Loosen the hose clamp and remove the intake pipe.


3. REMOVE INTAKE FLANGE

  1. A223438E01
    Remove the bolt and disconnect the heater water hose.
    Text in Illustration 
    *A
    w/o Rear Heater
    *B
    w/ Rear Heater

  1. A223439
    Disconnect the manifold absolute pressure sensor connector.

  1. A223440
    Disconnect the PCV hose.

  1. Remove the 3 nuts, intake flange and gasket.


4. REMOVE DIESEL THROTTLE BODY

  1. A223441
    Disconnect the throttle open switch connector.

  1. Disconnect the throttle control motor connector.

  1. Remove the diesel throttle body and gasket.

← COMPONENTS (from Aug 2013)INSPECTION (from Aug 2013) →