2013-2015 Land Cruiser Prado · Service Manual Drivetrain

INSTALLATION

Removal / installation · Vehicles built from Aug 2013


1. INSTALL CLUTCH DISC ASSEMBLY

  1. C215524E01
    Insert SST into the clutch disc. Then insert SST (together with the clutch disc) into the flywheel to install the clutch disc.
    SST
    09301-00110  
    Text in Illustration 
    V100135
    Flywheel Side

    NOTICE:
    Be sure to install the clutch disc so that it is facing in the correct direction.


2. INSTALL CLUTCH COVER ASSEMBLY

C215525E02
  1. Align the matchmarks on the clutch cover and flywheel.

    Text in Illustration 
    *a
    Matchmark

  1. Tighten the 6 bolts uniformly in the order shown in the illustration, starting with the bolt located near the knock pin on the top.

    SST
    09301-00110  

    Torque:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }

    HINT:
    Move SST up and down, and right and left lightly after checking that the clutch disc assembly is in the center, and then tighten the bolts.


3. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY

C215526E01
  1. Using a dial indicator with a roller instrument, measure the diaphragm spring tip alignment.

    SST
    09333-00013  

    Maximum non-alignment:
    0.5 mm (0.0196 in.)

    1. If the alignment is more than the maximum, use SST to adjust the diaphragm spring tip alignment.


4. INSTALL RELEASE FORK SUPPORT
  1. Install the release fork support to the manual transmission unit.

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }


5. INSTALL CLUTCH RELEASE BEARING ASSEMBLY

C215537E01
  1. Apply release hub grease to the clutch release bearing, and then install it to the clutch release fork with the clip.

    Grease:
    Toyota Genuine Release Hub Grease or equivalent

    Text in Illustration 
    *a
    Release hub grease


6. INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY
  1. Install the clutch release fork.

    NOTICE:
    After the installation, move the fork forward and backward to check that the release bearing slides smoothly.

  1. C215520E01
    Apply clutch spline grease to the spline of the input shaft.

    Grease:
    Toyota Genuine Clutch Spline Grease or equivalent

    Text in Illustration 
    *a
    Clutch spline grease


7. INSTALL CLUTCH RELEASE FORK BOOT

8. INSTALL MANUAL TRANSMISSION ASSEMBLY
  1. Install the manual transmission assembly (Click here).

← INSPECTION (from Aug 2013)COMPONENTS (from Aug 2013) →