2013-2015 Land Cruiser Prado · Service Manual Drivetrain

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT CLUTCH DISC ASSEMBLY

  1. C215522
    Using a vernier caliper, measure the rivet head depth.

    Minimum rivet head depth:
    0.3 mm (0.0118 in.)

    If the depth is less than the minimum, replace the clutch disc assembly.

  1. CL00373E01
    Using a dial indicator, check the disc runout.

    Maximum runout:
    0.8 mm (0.0315 in.)

    NOTICE:
    Be sure to measure on the correct side of the clutch disc.

    If the runout is more than the maximum, replace the clutch disc assembly.


INSPECT CLUTCH COVER ASSEMBLY

  1. C215523E01
    Using a vernier caliper, measure the depth and width of the worn areas of the diaphragm spring.

    Maximum Wear:
    Item
    Specified Condition
    Width
    6.0 mm (0.236 in.)
    Depth
    0.35 mm (0.0137 in.)

    Text in Illustration 
    *a
    Width
    *b
    Depth
    If the depth or width is more than the maximum, replace the clutch cover assembly.


INSPECT FLYWHEEL SUB-ASSEMBLY

  1. Q007250E01
    Using a dial indicator, measure the flywheel runout.

    Maximum runout:
    0.1 mm (0.00393 in.)

    If the runout is more than the maximum, replace the flywheel sub-assembly.


INSPECT CLUTCH RELEASE BEARING ASSEMBLY

  1. N000414E01
    Check that the bearing turns smoothly by hand by applying force in the axial direction.
    If the bearing sticks or has a considerable amount of resistance, replace the release bearing.

    HINT:
    The bearing is permanently lubricated and requires no cleaning or lubrication.


INSPECT INPUT SHAFT FRONT BEARING

  1. Q002481E01
    Check that the bearing turns smoothly by hand by applying rotational force.
    If the bearing sticks or has a considerable amount of resistance, replace the input shaft front bearing.

    HINT:
    The bearing is permanently lubricated and requires no cleaning or lubrication.


REPLACE INPUT SHAFT FRONT BEARING
  1. Remove any 2 diametrically opposite bolts.

  1. Q007150E01
    Using SST, remove the input shaft bearing.
    SST
    09303-35011  

  1. Q007151E03
    Using SST and a hammer, tap in a new bearing.
    SST
    09304-12012  

    HINT:
    After installing the bearing to the hub, make sure that it rotates smoothly.

  1. Apply adhesive to 2 or 3 threads of the bolts.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

  1. Install the 2 bolts.

    Torque:
    123 N*m{ 1249 kgf*cm , 90 ft.*lbf }

← REMOVAL (from Aug 2013)INSTALLATION (from Aug 2013) →