2013-2015 Land Cruiser Prado · Service Manual Power Source / Network

REMOVAL

Removal / installation · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE FAN AND GENERATOR V BELT
  1. Remove the fan and generator V belt (Click here).


3. DISCONNECT COOLER COMPRESSOR ASSEMBLY

  1. A225293
    Remove the 4 bolts and idle pulley bracket.

  1. A224370
    Disconnect the connector.

  1. Remove the 3 bolts and disconnect the cooler compressor.

    HINT:
    It is not necessary to completely remove the cooler compressor. With the hoses connected to the compressor, hang the compressor on the vehicle body with a rope.


4. REMOVE GENERATOR ASSEMBLY

  1. A224320
    Remove the terminal cap.

  1. Remove the nut and generator wire.

  1. Disconnect the generator connector.

  1. A224321
    Disconnect the vacuum pump hose.

  1. Remove the union bolt to disconnect the vacuum pump oil inlet hose and remove the 2 gaskets.

  1. Detach the vacuum pump oil inlet hose from the cord clip.

  1. Disconnect the vacuum pump oil outlet hose.

  1. A224322
    Remove the 2 bolts and generator.

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2014) →