2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE FRONT BUMPER COVER LOWER
  1. Remove the clip, 5 bolts and front bumper cover lower.


2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Remove the 4 bolts.

  1. A224743
    Unhook the engine under cover from the vehicle body as shown in the illustration.


3. REMOVE FRONT FENDER APRON SEAL RH
  1. Remove the 4 clips and fender apron seal.


4. REMOVE RESONATOR WITH AIR CLEANER CAP SUB-ASSEMBLY

  1. A224304
    Disconnect the sensor connector.

  1. Detach the wire harness clamp.

  1. Loosen the hose clamp and remove the resonator with air cleaner cap.

  1. A226728
    Detach the 4 hook clamps, and then remove the air cleaner cap and resonator with air cleaner cap.


5. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

6. REMOVE AIR CLEANER CASE ASSEMBLY

  1. A224627
    Remove the 3 bolts and air cleaner case.


7. REMOVE VANE PUMP V BELT

  1. A224878
    Loosen bolt and nut, and remove the V belt.


8. REMOVE COOLER COMPRESSOR V BELT

  1. A074095E03
    Loosen nut and adjusting bolt, and remove the V belt.
    Text in Illustration 
    *1
    Adjusting Bolt


9. REMOVE FAN AND GENERATOR V BELT

  1. A115632E03
    Loosen 2 bolts.

  1. Loosen adjusting bolt, and remove the V belt.

    Text in Illustration 
    *1
    Adjusting Bolt

← ON-VEHICLE INSPECTION (from Aug 2013)INSTALLATION (from Aug 2013) →