INSTALLATION
Removal / installation · Vehicles built from Aug 2013
| 1. INSTALL CRANKSHAFT POSITION SENSOR |
Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.
Install the crankshaft position sensor with the bolt and attach the 3 clamps.
- Torque:
- 8.5 N*m{ 87 kgf*cm , 75 in.*lbf }
Attach the connector to the vacuum transmitting pipe and connect the crankshaft position sensor connector.
| 2. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY |
Install the No. 1 engine under cover with the 4 bolts.
- Torque:
- 29 N*m{ 296 kgf*cm , 21 ft.*lbf }
| 3. INSTALL FRONT BUMPER LOWER COVER |
Install the lower front bumper cover with the clip and 5 bolts.
- Torque:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
