2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. DISCONNECT INLET HEATER WATER HOSE

  1. A224418
    Remove the bolt and disconnect the inlet heater water hose.


2. DISCONNECT NO. 4 VACUUM TRANSMITTING PIPE SUB-ASSEMBLY

  1. A222558
    Remove the bolt and disconnect the No. 4 vacuum transmitting pipe.


3. REMOVE NO. 1 INTAKE PIPE

  1. A222559
    Disconnect the 3 connectors from the intake air temperature sensor, throttle control motor and manifold absolute pressure sensor.

  1. Detach the 2 clamps.

  1. Disconnect the vacuum hose from the manifold absolute pressure sensor.

  1. A222560
    Loosen the 2 hose clamps of the No. 1 air hose.

  1. A222561
    Loosen the hose clamp of the intercooler air hose.

  1. A222562
    Remove the 2 bolts and No. 1 intake pipe.


4. REMOVE DIESEL THROTTLE BODY ASSEMBLY

  1. A222563
    Disconnect the throttle position sensor connector.

  1. A222564
    Remove the 2 bolts, 2 nuts, diesel throttle body and gasket.

← ON-VEHICLE INSPECTION (from Aug 2013)INSTALLATION (from Aug 2013) →