2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

  1. A239587E01
    Remove the 2 nuts.
    Text in Illustration 
    *1
    No. 1 Engine Cover Hook
    *2
    No. 3 Engine Cover Bracket

  1. Detach the 2 No. 1 engine cover hooks from the No. 3 engine cover bracket and remove the No. 1 engine cover.


2. DISCONNECT NO. 4 VACUUM TRANSMITTING PIPE SUB-ASSEMBLY

  1. A239589
    Remove the bolt and disconnect the No. 4 vacuum transmitting pipe.


3. DISCONNECT INTERCOOLER AIR HOSE

  1. A239590
    Loosen the hose clamp and disconnect the intercooler air hose.


4. REMOVE NO. 1 INTAKE PIPE

  1. A239592
    Disconnect the 2 connectors from the intake air temperature sensor and throttle position sensor.

  1. Detach the 2 wire harness clamps.

  1. A239593
    Loosen the 2 hose clamps of the No. 1 air hose.

  1. Remove the 2 bolts and No. 1 intake pipe.


5. REMOVE DIESEL THROTTLE BODY ASSEMBLY

  1. A239594
    Disconnect the throttle control motor connector.

  1. Remove the 2 bolts, 2 nuts, diesel throttle body and gasket.

← ON-VEHICLE INSPECTION (from Aug 2013)INSTALLATION (from Aug 2013) →