Front Passenger Side Seat Belt Warning Light Malfunction
Circuit diagnosis · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
The combination meter detects the state of the front seat inner belt RH*1 (or LH*2) when the front passenger seat is occupied with the ignition switch ON. If the front passenger seat belt is not fastened, the front seat belt warning light in the combination meter blinks. If the seat belt is fastened, the warning light goes off.- *1: for LHD
- *2: for RHD
- HINT:
- The seat belt warning light on the combination meter assembly is used for both the driver seat and front passenger seat.
WIRING DIAGRAM


INSPECTION PROCEDURE
- HINT:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. READ VALUE USING INTELLIGENT TESTER |
Check the Data List for proper functioning of the front passenger side seat belt buckle switch (Click here).
Combination Meter Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
P- Seatbelt Buckle SW
Front passenger side seat belt buckle signal / ON or OFF
ON: Front passenger side seat belt fastened
OFF: Front passenger side seat belt unfastened
-
- OK:
- The display is as specified in the normal condition column.
|
|
||||
| OK | |
| 2. INSPECT SEPARATE TYPE FRONT SEAT CUSHION PAD (OCCUPANT DETECTION SENSOR) |
![]() ![]() |
Remove the front seat assembly (Click here).
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
1 - 3
More than 147 N (15 kgf, 33.0 lbf) applied to occupant detection sensor
Below 100 Ω
|
|
||||
| OK | |
| 3. INSPECT FRONT SEAT INNER BELT ASSEMBLY |
Remove the front seat inner belt assembly RH*1 or LH*2 (Click here).

- *1: for LHD
- *2: for RHD
- *1: for LHD
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
2 (E) - 3
Always
Below 1 Ω
3 (+) - 1
Front passenger side seat belt unfastened
3 (+) - 1
Front passenger side seat belt fastened
10 kΩ or higher
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (COMBINATION METER - FRONT PASSENGER SIDE INNER BELT AND BODY GROUND) |
Disconnect the G7 meter connector.
Disconnect the Q21*1 or R34*2 inner belt connector.
- *1: for LHD
- *2: for RHD
- *1: for LHD
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
for LHD Tester Connection
Condition
Specified Condition
G7-15 (P/SB) - Q21-3 (+)
Always
Below 1 Ω
Q21-2 (E) - Body ground
G7-15 (P/SB) - Body ground
Always
10 kΩ or higher
for RHD Tester Connection
Condition
Specified Condition
G7-15 (P/SB) - R34-3 (+)
Always
Below 1 Ω
R34-2 (E) - Body ground
G7-15 (P/SB) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||

