2013-2015 Land Cruiser Prado · Service Manual Audio / Visual / Telematics

Sound Signal Circuit between Navigation Receiver Assembly and Television Display Assembly

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The television display assembly sends the sound signal to the navigation receiver assembly through this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, navigation receiver assembly or speakers.

WIRING DIAGRAM

E284346E02

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)
  1. Disconnect the H57 navigation receiver assembly connector.

  1. Disconnect the W14 television display assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H57-2 (CDR+) - W14-9 (R1+)
    Always
    Below 1 Ω
    H57-3 (CDR-) - W14-10 (R1-)
    Always
    Below 1 Ω
    H57-4 (CDL+) - W14-7 (L1+)
    Always
    Below 1 Ω
    H57-5 (CDL-) - W14-8 (L1-)
    Always
    Below 1 Ω
    W14-11(SLD1) - Body ground
    Always
    10 kΩ or higher
    H57-2 (CDR+) - Body ground
    Always
    10 kΩ or higher
    H57-3 (CDR-) - Body ground
    Always
    10 kΩ or higher
    H57-4 (CDL+) - Body ground
    Always
    10 kΩ or higher
    H57-5 (CDL-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Sound Signal Circuit between Headphone Terminal and Television Display (from Aug 2014)Sound Signal Circuit between Navigation Receiver Assembly and Television Display Assembly (from Aug 2014) →