INSTALLATION
Removal / installation · Vehicles built from Aug 2013
| 1. INSTALL INTAKE AIR TEMPERATURE SENSOR |
Using a 22 mm ball joint lock nut wrench, install a new gasket and the intake air temperature sensor.
- Torque:
- 34 N*m{ 350 kgf*cm , 25 ft.*lbf }
- NOTICE:
- Use the formula to calculate special torque values for situations where a ball joint lock nut wrench is combined with a torque wrench (Click here).
Connect the intake air temperature sensor connector.
| 2. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY |
Attach the 2 No. 1 engine cover hooks to the No. 3 engine cover bracket.

Text in Illustration *1
No. 1 Engine Cover Hook
*2
No. 3 Engine Cover Bracket
Install the 2 nuts.
- Torque:
- 12 N*m{ 122 kgf*cm , 9 ft.*lbf }
