2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSPECTION

Inspection · Vehicles built from Aug 2013

NOTICE:
Do not remove the electric vacuum regulating valve from the bracket.


INSPECT ELECTRIC VACUUM REGULATING VALVE ASSEMBLY (for EGR)

  1. A151146E04
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    11 to 13 Ω
    1 - Body ground
    2 - Body ground
    20°C (68°F)
    10 MΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Electric Vacuum Regulating Valve)
    If the result is not as specified, replace the electric EGR control valve assembly.

  1. A151813E04
    Check operation of the E-VRV.

    1. When a vacuum of 67 kPa (500 mmHg, 19.7 in.Hg) is applied to port F, check that air flows from port E to the filter.

      Text in Illustration 
      *1
      Port E
      *2
      Port F
      *3
      Vacuum
      *4
      Air
      *5
      Filter

    2. A151148E03
      Apply battery voltage across terminals 1 and 2.
      Text in Illustration 
      *1
      Port E
      *2
      Port F
      *3
      Air

    3. Check that air flows from port E to port F.
      If the result is not as specified, replace the electric EGR control valve assembly.

← REMOVAL (from Aug 2013)INSTALLATION (from Aug 2013) →