REMOVAL
Removal / installation · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
Discharge the fuel system pressure (Click here).
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
- NOTICE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
| 3. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY |
Remove the throttle body with motor assembly (Click here).
| 4. DISCONNECT NO. 2 FUEL HOSE |
![]() ![]() |
Disconnect the No. 2 fuel hose.
| 5. REMOVE FUEL PRESSURE REGULATOR |
![]() ![]() |
Disconnect the purge VSV connector.
Detach the wire harness clamp.
Remove the bolt and wire harness clamp bracket.
Remove the 3 bolts and fuel pressure regulator.



