2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE COOLER BRACKET

  1. E195732E01
    Detach the 2 clamps.
    Text in Illustration 
    *A
    except Model Code TRJ150L-GKMEKV, TRJ150L-GKPEKV, TRJ155L-GJPEKV
    *B
    Model Code TRJ150L-GKMEKV, TRJ150L-GKPEKV, TRJ155L-GJPEKV

  1. Remove the screw and cooler bracket.


2. REMOVE MAGNET CLUTCH ASSEMBLY

E195733E01
  1. Clamp the cooler compressor in a vise.

  1. Using SST, hold the magnet clutch hub.

    SST
    07112-76060  

  1. Remove the bolt, magnet clutch hub and magnet clutch washer.

    HINT:
    There is no set number of magnet clutch washers since they are used for adjusting.

  1. I104018
    Using a snap ring expander, remove the snap ring and magnet clutch rotor.

    NOTICE:
    Do not damage the seal cover of the bearing when removing the snap ring.

  1. Detach the connector clamp.

  1. I104019
    Using a snap ring expander, remove the snap ring and magnet clutch stator.

← REMOVAL (from Aug 2013)INSPECTION (from Aug 2013) →