2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. INSTALL MAGNET CLUTCH ASSEMBLY

E195723E01
  1. Install the magnet clutch stator with the parts shown in the illustration matched.

    Text in Illustration 
    *A
    except Model Code GRJ150L-GKFEKV, GRJ150L-GKAEKV
    *B
    Model Code GRJ150L-GKFEKV, GRJ150L-GKAEKV

  1. I032461
    Using a snap ring expander, install a new snap ring with the chamfered side facing up.

  1. Connect the connector.

  1. I031582
    Using a snap ring expander, install the magnet clutch rotor and a new snap ring with the chamfered side facing up.

    NOTICE:
    Do not damage the seal cover of the bearing when installing the snap ring.

  1. Install the compressor washer(s) and magnet clutch hub.

    NOTICE:
    Do not change the combination of the compressor washer(s) used before disassembly.

  1. E205223E01
    Using SST, hold the magnet clutch hub and install the bolt.
    SST
    09985-00270  
    07112-76060  
    Text in Illustration 
    *A
    for Single Air Conditioning System
    *B
    for Dual Air Condi

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    NOTICE:
    Make sure that there is no foreign matter or oil on the compressor shaft, bolt, and clutch hub.


2. INSTALL COOLER BRACKET
  1. Install the cooler bracket with the screw.

  1. Attach the clamp.


3. INSPECT MAGNET CLUTCH CLEARANCE
  1. Clamp the cooler compressor in a vise.

  1. Set the dial indicator to the magnet clutch hub.

  1. Connect the battery positive lead to terminal 3 of the magnet clutch connector and the negative lead to the ground wire. Turn the magnet clutch on and off and measure the clearance.

    Standard clearance:
    0.35 to 0.60 mm (0.014 to 0.024 in.)

    If the measured value is not within the standard clearance, remove the magnet clutch hub and adjust the clearance using compressor washers to obtain the standard clearance.

    Compressor washer thickness:
    0.1 mm (0.004 in.)
    0.3 mm (0.012 in.)
    0.5 mm (0.020 in.)

    NOTICE:
    Adjustment should be performed with 3 or fewer magnet clutch washers.

  1. Remove the cooler compressor from the vise.

    E205226E01

    Text in Illustration 
    *A
    for Single Air Conditioning System
    *B
    for Dual Air Conditioning System
    *1
    Battery
    -
    -
    *a
    Component without harness connected
    (Magnet Clutch Assembly)
    -
    -

← INSPECTION (from Aug 2013)INSTALLATION (from Aug 2013) →