2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. INSTALL MAGNET CLUTCH ASSEMBLY

  1. E195735E01
    Install the magnet clutch stator with the parts aligned as shown in the illustration.
    Text in Illustration 
    *A
    except Model Code TRJ150L-GKMEKV, TRJ150L-GKPEKV, TRJ155L-GJPEKV
    *B
    Model Code TRJ150L-GKMEKV, TRJ150L-GKPEKV, TRJ155L-GJPEKV

  1. I032461E01
    Using a snap ring expander, install a new snap ring with the chamfered side facing outward.

  1. Attach the connector clamp.

  1. I031582E01
    Using a snap ring expander, install the magnet clutch rotor and a new snap ring with the chamfered side facing outward.

    NOTICE:
    Do not damage the seal cover of the bearing when installing the snap ring.

  1. Install the magnet clutch washer and magnet clutch hub.

    NOTICE:
    Do not change the combination of magnet clutch washer used before disassembly.

  1. E195736E01
    Using SST, hold the magnet clutch hub and install the bolt.
    SST
    07112-76060  

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    NOTICE:
    Make sure that there is no foreign matter or oil on the compressor shaft, bolt and clutch hub.


2. INSTALL COOLER BRACKET

  1. E195732E01
    Connect the ground wire and install the cooler bracket with the screw.
    Text in Illustration 
    *A
    except Model Code TRJ150L-GKMEKV, TRJ150L-GKPEKV, TRJ155L-GJPEKV
    *B
    Model Code TRJ150L-GKMEKV, TRJ150L-GKPEKV, TRJ155L-GJPEKV

  1. Attach the 2 clamps.


3. INSPECT MAGNET CLUTCH CLEARANCE

  1. E195737E01
    Clamp the cooler compressor in a vise between aluminum plates.
    Text in Illustration 
    *1
    Battery
    *a
    Component without harness connected
    (Magnet Clutch Assembly)

  1. Set a dial indicator to the magnet clutch hub.

  1. Connect the battery positive (+) lead to terminal 1 of the magnet clutch connector. Turn the magnet clutch on and off by connecting and disconnecting the battery negative (-) lead to and from the ground wire and measure the clearance.

    Standard clearance:
    0.35 to 0.60 mm (0.014 to 0.024 in.)

    If the measured value is not within the standard clearance, remove the magnet clutch hub and adjust the clearance using magnet clutch washers to obtain the standard clearance.

    Magnet clutch washer thickness:
    0.1 mm (0.004 in.)
    0.3 mm (0.012 in.)
    0.5 mm (0.020 in.)

    NOTICE:
    Adjustment should be performed with 3 magnet clutch washers or less.

  1. Remove the cooler compressor from the vise.

← INSPECTION (from Aug 2013)INSTALLATION (from Aug 2013) →