2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. INSTALL MAGNET CLUTCH ASSEMBLY

E195762E01
Text in Illustration 
*A
for Type A
*B
for Type B
  1. Install the magnet clutch stator with the parts shown in the illustration aligned.

  1. I032461E01
    Using a snap ring expander, install a new snap ring with the chamfered side facing up.

  1. Connect the connector.

  1. I031582E01
    Using a snap ring expander, install the magnet clutch rotor and a new snap ring with the chamfered side facing up.

    NOTICE:
    Do not damage the seal cover of the bearing when installing the snap ring.

  1. Install the compressor washer and magnet clutch hub.

    NOTICE:
    Do not change the combination of the compressor washer used before disassembly.

  1. E195763E01
    Using SST, hold the magnet clutch hub and install the bolt.
    SST
    09985-00270  

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    NOTICE:
    Make sure that there is no foreign matter or oil on the compressor shaft, bolt and clutch hub.


2. INSTALL COOLER BRACKET

E195759
  1. Install the cooler bracket with the screw.

  1. Attach the clamp.


3. INSPECT MAGNET CLUTCH CLEARANCE

E201336E01
Text in Illustration 
*1
Battery
*a
Component without harness connected
(Magnet Clutch Assembly)
  1. Clamp the cooler compressor in a vise.

  1. Set a dial indicator to the magnet clutch hub.

  1. Connect the battery positive (+) lead to terminal 1 of the magnet clutch connector. Turn the magnet clutch on and off by connecting and disconnecting the battery negative (-) lead to and from the ground wire and measure the clearance.

    Standard clearance:
    0.35 to 0.60 mm (0.014 to 0.024 in.)

    If the measured value is not within the standard clearance, remove the magnet clutch hub and adjust the clearance using compressor washers to obtain the standard clearance.

    Compressor washer thickness:
    0.1 mm (0.004 in.)
    0.3 mm (0.012 in.)
    0.5 mm (0.020 in.)

    NOTICE:
    Adjustment should be performed with 3 magnet clutch washers or less.

  1. Remove the cooler compressor from the vise.

← INSPECTION (from Aug 2013)INSTALLATION (from Aug 2013) →