2013-2015 Land Cruiser Prado · Service Manual Drivetrain

REMOVAL

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH side.
  2. The procedure listed below is for the LH side.


1. REMOVE FRONT WHEEL

2. DRAIN DIFFERENTIAL OIL
  1. Stop the vehicle on a level surface.

  1. Remove the differential drain plug and gasket.

  1. Drain the oil.

  1. Install a new gasket and the differential drain plug.

    Torque:
    Front differential carrier:
    65 N*m{ 660 kgf*cm , 48 ft.*lbf }
    Rear differential carrier:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }


3. REMOVE FRONT AXLE HUB GREASE CAP
  1. Using a screwdriver and hammer, remove the front axle hub grease cap.

    NOTICE:
    Do not damage the axle hub.


4. REMOVE FRONT AXLE SHAFT NUT

  1. F042732
    Remove the cotter pin and lock cap.

  1. Remove the front axle shaft nut.


5. REMOVE FRONT SPEED SENSOR
  1. Remove the bolt and speed sensor from the knuckle.

    NOTICE:
    Pull out the sensor while trying as much as possible not to rotate it.


6. DISCONNECT TIE ROD END SUB-ASSEMBLY LH

  1. C215754E01
    Using SST, disconnect the tie rod end assembly.
    SST
    09610-20012  


7. DISCONNECT FRONT LOWER BALL JOINT ATTACHMENT LH

  1. F042737
    Remove the 2 bolts and disconnect the lower ball joint attachment from the steering knuckle.


8. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH

  1. F042739E01
    Using SST, remove the front drive shaft.
    SST
    09520-01010  
    09520-24010   (09520-32040)

    NOTICE:
    1. Be careful not to damage the dust cover or oil seal.
    2. Keep the drive shaft level while handling it.

← COMPONENTS (from Aug 2013)DISASSEMBLY (from Aug 2013) →