2013-2015 Land Cruiser Prado · Service Manual Drivetrain

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP
  1. Hold the drive shaft lightly in a vise between aluminum plates.

  1. C108564
    Using pliers, remove the front No. 2 axle inboard joint boot clamp as shown in the illustration.


2. REMOVE FRONT NO. 1 AXLE INBOARD JOINT BOOT CLAMP
  1. Remove the front axle inboard joint boot clamp.

    HINT:
    Perform the same procedures described for the front No. 2 axle inboard joint boot clamp.


3. REMOVE FRONT AXLE INBOARD JOINT BOOT

4. REMOVE FRONT AXLE INBOARD JOINT ASSEMBLY

  1. FA01615E05
    Place matchmarks on the tripod and the inboard and outboard joint shafts.
    Text in Illustration 
    *a
    Matchmark

    NOTICE:
    Do not punch the marks.

  1. Remove the inboard joint from the outboard joint shaft.

  1. G022501
    Using a snap ring expander, remove the snap ring.

  1. C183637E02
    Place matchmarks on the outboard joint shaft and tripod.
    Text in Illustration 
    *a
    Matchmark

    NOTICE:
    Do not punch the marks.

  1. Using a brass bar and hammer, remove the tripod from the drive shaft.

    NOTICE:
    Do not tap the roller.


5. REMOVE FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP

  1. C063445
    Using a screwdriver, remove the outboard joint boot clamps.

    HINT:
    If the outboard joint boot clamps that have been replaced are installed to the drive shaft, use a side cutter to remove them.


6. REMOVE FRONT NO. 1 AXLE OUTBOARD JOINT BOOT CLAMP

  1. C081566
    Using pliers, remove the boot clamp as shown in the illustration.


7. REMOVE OUTBOARD JOINT BOOT

8. REMOVE SHAFT SNAP RING

  1. C057543
    Using a screwdriver, remove the snap ring.


9. REMOVE FRONT DRIVE SHAFT DUST COVER

  1. F040647E18
    Using SST and a press, remove the dust cover.
    SST
    09950-00020  

← REMOVAL (from Aug 2013)INSPECTION (from Aug 2013) →