2013-2015 Land Cruiser Prado · Service Manual Drivetrain

REMOVAL

Removal / installation · Vehicles built from Aug 2013

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. w/ Navigation System (for HDD):
    After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
  2. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE REAR WHEEL

3. DRAIN BRAKE FLUID

4. DISCONNECT REAR FLEXIBLE HOSE LH

  1. F043125
    Remove the union bolt and gasket from the rear disc brake cylinder, and then disconnect the rear flexible hose from the rear disc brake cylinder.

    HINT:
    Use a container to catch brake fluid as it drains out.


5. REMOVE REAR SPEED SENSOR LH

  1. C212844
    Disconnect the speed sensor connector.

  1. Remove the nut and speed sensor.

    NOTICE:
    Pull out the sensor while trying as much as possible not to rotate it.


6. REMOVE PARKING BRAKE ASSEMBLY
  1. Remove the parking brake assembly (Click here).


7. REMOVE REAR AXLE SHAFT WITH PARKING BRAKE PLATE LH

  1. F042741
    Remove the 4 nuts and rear axle shaft with parking brake plate.

  1. Remove the O-ring.


8. REMOVE REAR AXLE SHAFT OIL SEAL LH

F042742E01
  1. Using SST, remove the rear axle shaft oil seal.

    SST
    09308-00010  

← COMPONENTS (from Aug 2013)DISASSEMBLY (from Aug 2013) →