2013-2015 Land Cruiser Prado · Service Manual Drivetrain

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013

NOTICE:
Do not allow foreign matter, etc. to contact the rear axle hub and bearing assembly.


1. INSTALL BRAKE DRUM OIL DEFLECTOR LH

G020977E02
  1. Install a new deflector gasket and deflector to the rear axle shaft.

    HINT:
    Align the 2 oil drain holes.

    Text in Illustration 
    *1
    Oil Drain Holes

  1. Insert 6 new hub bolts.

  1. G020973
    Temporarily install a washer and nut to each hub bolt as shown in the illustration.

  1. Install the hub bolts by tightening each nut.

  1. Remove the washer and nut from each hub bolt.


2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH
  1. Install a new rear axle hub and bearing to the parking brake plate.

    NOTICE:
    Make sure the bearing is securely installed to the parking brake plate.

  1. F042777E01
    Using 2 socket wrenches and a press, press in the 4 housing bolts.


3. INSTALL REAR AXLE SHAFT LH

G022121E02
  1. Install a new washer and a new retainer to the axle hub as shown in the illustration.

    NOTICE:
    1. Install the washer with its tapered surface facing downward.
    2. Install the retainer with its chamfered surface facing downward.

    Text in Illustration 
    *a
    Tapered Surface
    *b
    Chamfered Surface

  1. Using SST and a press, press in the rear axle shaft.

    SST
    09631-12090  
    09726-40010  
    09951-01100  

    NOTICE:
    Make sure the bearing is securely installed to the rear axle shaft.


4. INSTALL REAR AXLE SHAFT SNAP RING LH

F042773E01
  1. Using snap ring expander, install a new rear axle shaft snap ring.

← INSPECTION (from Aug 2013)INSTALLATION (from Aug 2013) →