2013-2015 Land Cruiser Prado · Service Manual Drivetrain

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. DRAIN BRAKE FLUID FROM CLUTCH LINE

2. DISCONNECT CLUTCH RESERVOIR TUBE

C215412
  1. Disconnect the clutch reservoir tube.

    HINT:
    Use a container to collect the fluid.


3. DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE

C215413
  1. Using a union nut wrench, disconnect the flexible hose tube.

    HINT:
    Use a container to collect the fluid.


4. REMOVE DRIVER SIDE JUNCTION BLOCK ASSEMBLY
  1. Remove the driver side junction block (Click here).


5. REMOVE CLUTCH PEDAL WITH CLUTCH MASTER CYLINDER
  1. Disconnect the clutch start switch connector.

  1. w/ Cruise Control:
    Disconnect the clutch switch connector.

  1. C215414
    Remove the 2 nuts, bolt and clutch pedal with clutch master cylinder.


6. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY

  1. C215415
    Disconnect the clutch reservoir hose.

  1. C215416
    Using a union nut wrench, disconnect the flexible tube.

  1. C215417
    Remove the nut and clutch start switch from the clutch pedal support.

  1. C215418
    Remove the clip and pin, and separate the push rod clevis from the clutch pedal.

  1. C215419
    Remove the 2 bolts and clutch master cylinder.

← COMPONENTS (from Aug 2013)INSTALLATION (from Aug 2013) →