2013-2015 Land Cruiser Prado · Service Manual Drivetrain

INSTALLATION

Removal / installation · Vehicles built from Aug 2013


1. INSTALL CLUTCH START SWITCH ASSEMBLY
  1. for LHD:

    1. Install the clutch start switch assembly with the nut.

      Torque:
      16 N*m{ 160 kgf*cm , 12 ft.*lbf }

    2. Connect the clutch start switch connector.

  1. for RHD:

    1. Install the clutch start switch assembly with the nut.

      Torque:
      16 N*m{ 160 kgf*cm , 12 ft.*lbf }

    2. Connect the clutch start switch connector and attach the clamp.


2. INSPECT CLUTCH START SWITCH ASSEMBLY

C175625E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    On (Pushed)
    Below 1 Ω
    1 - 2
    Off (Not pushed)
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Clutch Start Switch Assembly)
    *b
    On: 7.65 to 8.35 mm (0.302 to 0.328 in.)
    *c
    Off: 1.65 to 2.35 mm (0.0650 to 0.0925 in.)
    If the result is not as specified, replace the clutch start switch assembly.

← INSPECTION (from Aug 2013)PROBLEM SYMPTOMS TABLE (from Aug 2013) →