2013-2015 Land Cruiser Prado · Service Manual Drivetrain

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT CLUTCH START SWITCH ASSEMBLY

C175625E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    On (Pushed)
    Below 1 Ω
    1 - 2
    Off (Not pushed)
    10 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Clutch Start Switch Assembly)
    *b
    On: 7.65 to 8.35 mm (0.302 to 0.328 in.)
    *c
    Off: 1.65 to 2.35 mm (0.0650 to 0.0925 in.)
    If the result is not as specified, replace the clutch start switch assembly.

← REMOVAL (from Aug 2013)INSTALLATION (from Aug 2013) →