2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

REASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. INSTALL STARTER ARMATURE ASSEMBLY
  1. Install the starter armature to the starter yoke.


2. INSTALL STARTER BRUSH HOLDER ASSEMBLY
  1. Install the brush holder.

  1. Connect the 4 brushes to the starter brush holder.

    1. Using a screwdriver, hold back the spring.

    2. Connect the brush to the brush holder.

      NOTICE:
      Check that the positive (+) lead wires are not grounded

  1. Install a new O-ring to the groove of the commutator end frame.

  1. Install the commutator end frame with the 2 screws.

    Torque:
    3.8 N*m{ 39 kgf*cm , 34 in.*lbf }


3. INSTALL MAGNET STARTER SWITCH ASSEMBLY
  1. Apply high temperature grease to the idle gear, steel ball, return spring, clutch roller and retainer.

  1. A222255
    Insert the steel ball into the starter clutch hole.

  1. Insert the return spring into the starter clutch hole.

  1. Install the starter clutch, idle gear, retainer and clutch roller to the starter drive housing.

  1. Install the starter drive housing to the magnet starter switch with the 2 bolts.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }


4. INSTALL STARTER YOKE ASSEMBLY
  1. Install a new O-ring to the groove of the starter yoke.

  1. P013095E03
    Align the claw of the starter yoke with the groove of the starter switch.
    Text in Illustration 
    *1
    Claw
    *2
    Groove

  1. Install the starter yoke to the magnet starter switch with the 2 through bolts.

    Torque:
    9.3 N*m{ 95 kgf*cm , 82 in.*lbf }

  1. Connect the lead wire to terminal C with the nut.

    Torque:
    5.9 N*m{ 60 kgf*cm , 52 in.*lbf }

← INSPECTION (from Aug 2013)INSTALLATION (Aug 2013 – Jul 2014) →