2013-2015 Land Cruiser Prado · Service Manual Power Source / Network

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE GENERATOR PULLEY CAP

  1. A223933
    Using a screwdriver, remove the generator pulley cap.


2. REMOVE GENERATOR WITH CLUTCH PULLEY
  1. Mount the generator in a vise between aluminum plates.

  1. A219545E01
    Install SST (A) and SST (B) to the generator with clutch pulley as shown in the illustration.
    SST
    09820-63021  
    Text in Illustration 
    *1
    Rotor Shaft

    NOTICE:
    Securely attach SST to the generator with clutch pulley and generator rotor shaft.

  1. A219546E01
    Use a wrench to hold SST (A) and turn SST (B) counterclockwise to loosen the generator with clutch pulley.
    Text in Illustration 
    *a
    Hold
    V100135
    Turn

    NOTICE:
    Be careful as the generator with clutch pulley or generator rotor shaft may be damaged if the position of SST is not securely maintained while performing this operation.

  1. Remove SST from the generator.

  1. Remove the generator with clutch pulley from the rotor shaft.


3. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY

  1. A220456
    Remove the nut, screw and rectifier plate.

  1. Remove the 2 nuts and rear end cover.

  1. Remove the nut and terminal insulator.

  1. A220291
    Remove the brush cover from the generator brush holder.

  1. Remove the 3 screws and generator brush holder.

  1. Remove the plate seal.


4. REMOVE GENERATOR REGULATOR ASSEMBLY

  1. A220292
    Remove the 2 screws and generator regulator.


5. REMOVE GENERATOR HOLDER WITH RECTIFIER

  1. A220293
    Remove the 3 screws and generator holder with rectifier.


6. REMOVE GENERATOR ROTOR ASSEMBLY

  1. A220294
    Remove the 3 terminal insulators from the rectifier end frame.

  1. Remove the 4 nuts.

  1. A220295E01
    Using SST, remove the rectifier end frame.
    SST
    09286-46011  
    Text in Illustration 
    *a
    Hold
    V100135
    Turn

  1. Remove the washer.

  1. A224328
    Remove the generator rotor from the drive end frame.

    NOTICE:
    Do not drop the generator rotor assembly.

← REMOVAL (from Aug 2014)INSPECTION (from Aug 2013) →