2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT CAMSHAFT POSITION SENSOR
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (G+) - 2 (G-)
    Cold
    835 to 1400 Ω
    Hot
    1060 to 1645 Ω

    HINT:
    In the table above, the terms "cold" and "hot" refer to the temperature of the sensor. "Cold" mean approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).

    If the result is not as specified, replace the camshaft position sensor.

← REMOVAL (from Aug 2013)INSTALLATION (from Aug 2013) →