2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013


CHECK OIL QUALITY
  1. Check the oil for deterioration, water contamination, discoloring or thinning.
    If the quality is visibly poor, replace the oil and oil filter element (Click here).


CHECK ENGINE OIL LEVEL
  1. Warm up the engine, and then stop the engine and wait for 5 minutes.

  1. Check that the engine oil level is between the low level and full level marks on the dipstick.
    If low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not fill engine oil above the full level mark.


INSPECT OIL PRESSURE
  1. Remove the oil pressure switch (Click here).

  1. A222096E03
    Install an oil pressure gauge.
    Text in Illustration 
    *1
    Oil Pressure Gauge

  1. Warm up the engine.

  1. Inspect the oil pressure.

    Standard Oil Pressure:
    Condition
    Specified Condition
    Idling
    29 kPa (0.3 kgf/cm2, 4.2 psi) or higher
    3000 rpm
    294 to 588 kPa (3.0 to 6.0 kgf/cm2, 43 to 85 psi)

    If the pressure is not as specified, check the oil pump (Click here).

  1. Remove the oil pressure gauge.

  1. Install the oil pressure switch (Click here).

← INSTALLATION (from Aug 2013)COMPONENTS (from Aug 2013) →