P0606 ECM / PCM Processor
Diagnostic trouble codes · Vehicles built from Aug 2014
Also covers:
- P060A Internal Control Module Monitoring Processor Performance
- P060B Internal Control Module A/D Processing Performance
- P1607 Cruise Control Input Processor
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
| DTC Detection Drive Pattern |
DTC Detection Condition |
Trouble Area |
| Ignition switch ON for 1 second |
ECM internal error continues for 1 second (1 trip detection logic). |
ECM |
INSPECTION PROCEDURE
- NOTICE:
- After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).
| 1. REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 2. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED |
Connect the intelligent tester to the DLC3.
Clear the DTCs (Click here).
Turn the ignition switch off for 30 seconds or more.
Turn the ignition switch to ON for 1 second.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Confirm that the DTC is not output again.
| NEXT | ||
| ||
