REMOVAL
Removal / installation · Vehicles built from Aug 2013
- HINT:
- Use the same procedure for RHD and LHD vehicles.
- The procedure listed below is for LHD vehicles.
- Use the same procedure for RHD and LHD vehicles.
| 1. REMOVE COOLER THERMISTOR (ROOM TEMPERATURE SENSOR) |
![]() ![]() |
Put protective tape around the cooler thermistor.
Using a screwdriver, detach the 4 claws and remove the sensor, and then disconnect the connector.
- HINT:
- Tape the screwdriver tip before use.
Text in Illustration *1
Protective Tape


