2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

Headlight (HI-BEAM) Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The main body ECU receives headlight dimmer switch information signals and illuminates the high beam headlights.

WIRING DIAGRAM

E199761E05

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (HEADLIGHT)
  1. Using the intelligent tester, perform the Active Test (Click here).

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Head Light Hi
    Headlight dimmer relay
    ON/OFF
    -

    OK:
    Relay operates (high beam headlights illuminate).



NG
Go to step 2
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)

2. INSPECT HEADLIGHT RELAY (H-LP HI)

  1. E108359E03
    Remove the headlight relay from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Battery voltage applied between terminals 1 and 2
    Below 1 Ω



NG
REPLACE HEADLIGHT RELAY (H-LP HI)
OK


3. CHECK HARNESS AND CONNECTOR (HEADLIGHT RELAY [H-LP HI] - BATTERY)

  1. E199762E01
    Remove the headlight relay from the engine room relay block.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    Headlight dimmer relay terminal 1 - Body ground
    Always
    11 to 14 V
    Headlight dimmer relay terminal 5 - Body ground

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Headlight Dimmer Relay)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (HEADLIGHT RELAY [H-LP HI] - MAIN BODY ECU AND BODY GROUND)
  1. Remove the headlight relay from the engine room relay block.

  1. Disconnect the G64 main body ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Headlight dimmer relay terminal 2 - G64-15 (DIM)
    Always
    Below 1 Ω
    G64-15 (DIM) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Headlight (HI-BEAM) Circuit (Aug 2013 – Jul 2014)Front Fog Light Circuit (Aug 2013 – Jul 2014) →