2013-2015 Land Cruiser Prado · Service Manual Steering

Power Steering Warning Light Circuit

Circuit diagnosis · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The power steering ECU is connected to the combination meter via CAN communication. If the power steering ECU detects a malfunction, the power steering warning light comes on. At this time, the vehicle enters fail-safe mode.

WIRING DIAGRAM

C216948E02

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. INSPECT CAN COMMUNICATION SYSTEM
  1. Check for DTCs of the CAN communication system.for LHD with Entry and Start System:Refer to the following procedures (Click here).for LHD without Entry and Start System:Refer to the following procedures (Click here).for RHD with Entry and Start System:Refer to the following procedures (Click here).for RHD without Entry and Start System:Refer to the following procedures (Click here).

    Result 
    Result
    Proceed to
    DTC is not output.
    A
    DTC is output.
    for LHD with Entry and Start System
    B
    for LHD without Entry and Start System
    C
    for RHD with Entry and Start System
    D
    for RHD without Entry and Start System
    E



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)

D
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)

E
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A


2. CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BATTERY AND BODY GROUND)

  1. C214365E01
    Disconnect the power steering ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    G46-5 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G46-3 (GND) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Power Steering ECU)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (METER/GAUGE SYSTEM)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON and turn the intelligent tester on.

  1. Perform the Active Test of the combination meter using the intelligent tester (Click here).

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    PPS Indicator
    Power steering warning light
    ON or OFF
    Perform the test with the vehicle stopped and the engine idling.

  1. Check that the power steering warning light operates in accordance with the Active Test.

    HINT:
    Reconnect the connectors and restore the vehicle to its previous condition before checking the combination meter.

    OK:
    The power steering warning light turns on and off in accordance with the intelligent tester operation.



NG
INSPECT METER/GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)


← Power Steering Warning Light Circuit (Aug 2013 – Jul 2014)IG Power Source Circuit (Aug 2013 – Jul 2014) →