2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
  1. Use these procedures to troubleshoot the meter/gauge system.
  2. *: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    3.CHECK FOR DTC*
    1. Use the intelligent tester to check if the CAN communication system is functioning normally.

      Result 
      Result
      Proceed to
      DTC is not output
      A
      CAN DTC is output (for LHD with Entry and Start System)
      B
      CAN DTC is output (for LHD without Entry and Start System)
      C
      CAN DTC is output (for RHD with Entry and Start System)
      D
      CAN DTC is output (for RHD without Entry and Start System)
      E


    B.

    C.

    D.

    E.
    A

    4.CHECK FOR DTC*
    1. Check for DTCs (Click here)

    2. Clear the DTCs (Click here)

    3. Recheck for DTCs (Click here)

      Result 
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B


    A.
    B

    5.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    A

    6.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here)

    2. Data List / Active Test (Click here)

    3. Operation Check (Click here)

    NEXT

    7.REPAIR OR REPLACE
      NEXT

      8.CONFIRMATION TEST
        NEXT

        ← HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2013 – Jul 2014)OPERATION CHECK (from Aug 2013) →