2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

INSPECTION

Inspection · Vehicles built from Aug 2013


INSPECT PURGE VSV
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    23 to 26 Ω
    1 - Body ground
    Always
    10 MΩ or higher
    2 - Body ground

    HINT:
    When measuring the coil resistance make sure that the surface temperature of the purge VSV is 20°C.

    If the result is not as specified, replace the purge VSV.

  1. Check the operation.

    1. A160987E02
      Check that air does not flow from port E to port F.
      Text in Illustration 
      *1
      Port E
      *2
      Port F
      V100135
      Air

    2. Apply battery voltage across the terminals.

    3. A160988E02
      Check that air flows from port E to port F.
      Text in Illustration 
      *1
      Port E
      *2
      Port F
      V100135
      Air
      If the result is not as specified, replace the purge VSV.

← REMOVAL (from Aug 2013)INSTALLATION (from Aug 2013) →