2013-2015 Land Cruiser Prado · Service Manual Brake

Skid Control Buzzer Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The skid control buzzer sounds upon receiving a signal from the skid control ECU.

WIRING DIAGRAM

C173348E05

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (DSS SIGNAL BUZZER)
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.

    ABS/VSC/TRC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    DSS Signal Buzzer
    Skid control buzzer
    Buzzer ON/OFF
    The buzzer can be heard.

  1. Check that the skid control buzzer sounds/stops when turning the skid control buzzer on/off by using the intelligent tester.

    Result 
    Result
    Proceed to
    Buzzer does not sound or sounds constantly
    A
    Buzzer sounds/stops
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A


2. CHECK TERMINAL VOLTAGE (IG1)
  1. Disconnect the A12 skid control buzzer connector.

  1. C216859E04
    Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A12-2 (IG1) - Body ground
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Skid Control Buzzer)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT SKID CONTROL BUZZER
  1. Remove the skid control buzzer (Click here).

  1. C208381E04
    Apply battery voltage to the skid control buzzer, and check that the buzzer sounds.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) voltage - Terminal 2 (IG1)
    Skid control buzzer sounds
    Battery negative (-) voltage - Terminal 1 (BZ)

    Text in Illustration 
    *a
    Component without harness connected
    (Skid Control Buzzer)



NG
REPLACE SKID CONTROL BUZZER ASSEMBLY (Click here)
OK


4. CHECK HARNESS AND CONNECTOR (SKID CONTROL BUZZER - SKID CONTROL ECU)
  1. Disconnect the A7 skid control ECU connector.

  1. Disconnect the A12 skid control buzzer connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A7-30 (BZ) - A12-1 (BZ)
    Always
    Below 1 Ω
    A7-30 (BZ) - Body ground
    Always
    10 kΩ or higher

    Result 
    Result
    Proceed to
    NG
    A
    OK (for LHD)
    B
    OK (for RHD)
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

REPAIR OR REPLACE HARNESS OR CONNECTOR


← Downhill Assist Control Indicator Light does not Come ON (from Aug 2014)Skid Control Buzzer Circuit (from Aug 2014) →