2013-2015 Land Cruiser Prado · Service Manual Brake

C1254 Pressure Sensor or Switch

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

The accumulator pressure sensor is connected to the skid control ECU in the master cylinder solenoid.
C173281E04
DTC Code
DTC Detection Condition
Trouble Area
C1254
There is an accumulator pressure sensor malfunction (the fluid pressure does not change when the pump operates or when the brake is applied).
Master cylinder solenoid (Accumulator pressure sensor)

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).


1. READ VALUE USING INTELLIGENT TESTER (ACCUMULATOR SENSOR)
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Depress the brake pedal more than 40 times.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

    ABS/VSC/TRC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Accumulator Sensor
    Accumulator pressure sensor reading/ Min.: 0.00 V, Max.: 5.00 V
    3.58 to 5 V
    If the value is constant regardless of the pump operation, an accumulator pressure sensor malfunction is suspected.

  1. Check the accumulator output value.

    Result 
    Result
    Proceed to
    Output value is within "Normal Condition" range
    A
    Output value is out of "Normal Condition" range (for LHD)
    B
    Output value is constant regardless of pump operation (for LHD)
    Output value is out of "Normal Condition" range (for RHD)
    C
    Output value is constant regardless of pump operation (for RHD)



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A


2. RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Depress the brake pedal more than 40 times.

  1. Turn the ignition switch to ON.

  1. Wait until the pump motor stops.

  1. Wait for 15 minutes.

  1. Depress the brake pedal and release it.

  1. Check if the same DTC is output (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for LHD)
    B
    DTC is output (for RHD)
    C



B
REPLACE MASTER CYLINDER SOLENOID (Click here)

C
REPLACE MASTER CYLINDER SOLENOID (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C1253 Pump Motor Relay (from Aug 2014)C1254 Pressure Sensor or Switch (from Aug 2014) →