C1268 Transfer L4 Position Switch Circuit
Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
DESCRIPTION
| DTC Code |
DTC Detection Condition |
Trouble Area |
| C1268 |
The skid control ECU receives an L4 abnormal status signal from the four wheel drive control ECU via CAN. |
|
INSPECTION PROCEDURE
- NOTICE:
- When replacing the brake actuator assembly, perform calibration (Click here).
| 1. INSPECT TRANSFER L4 SHIFT |
Shift the transfer to L4, and then drive the vehicle and check that there are no problems with the transfer system.
- OK:
- There are no problems with the transfer system.
|
|
||||
| OK | |
| 2. RECONFIRM DTC |
Clear the DTCs (Click here).
Shift the transfer to L4, drive the vehicle, and then check for DTCs (Click here).
Result Result
Proceed to
DTC is output
A
DTC is not output
B
|
|
||||
| A | ||
| ||
