2013-2015 Land Cruiser Prado · Service Manual Suspension

DTC CHECK / CLEAR

Troubleshooting · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


CHECK DTC (When Using Intelligent Tester)
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Chassis / Air suspension / DTC.

  5. Read the output DTCs by following the prompts on the intelligent tester screen.

    HINT:
    Refer to the intelligent tester operator's manual for further details.

  6. Refer to the Diagnostic Trouble Code Chart for DTC information (Click here).


CHECK DTC (When Using SST Check Wire)
  1. Turn the ignition switch off.

  2. C146309E17
    Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
    SST
    09843-18040  

    NOTICE:
    Do not connect the incorrect terminals as this will cause damage.

    Text in Illustration 
    *a
    Front view of DLC3

  3. Turn the ignition switch to ON.

  4. Read the output DTCs from the multi-information display on the combination meter.

  5. Refer to the Diagnostic Trouble Code Chart for DTC information (Click here).


CLEAR DTC (When Using Intelligent Tester)

HINT:
After repairing the malfunctions, clear the DTCs.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Chassis / Air suspension / DTC.

  5. Clear the DTCs by following the prompts on the intelligent tester screen.

    HINT:
    Refer to the intelligent tester operator's manual for further details.


CLEAR DTC (When Using SST Check Wire)
  1. Turn the ignition switch off.

  2. C146309E17
    Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
    SST
    09843-18040  

    NOTICE:
    Do not connect the incorrect terminals as this will cause damage.

    Text in Illustration 
    *a
    Front view of DLC3

  3. Turn the ignition switch to ON.

  4. Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

  5. Check that no DTCs are output to the multi-information display.

  6. Turn the ignition switch off.

  7. Remove SST from the terminals of the DLC3.

    NOTICE:
    As data for other systems may be cleared and DTCs may be stored, be sure to check for DTCs.

← DIAGNOSIS SYSTEM (from Aug 2014)DTC CHECK / CLEAR (from Aug 2014) →