2013-2015 Land Cruiser Prado · Service Manual Drivetrain

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Aug 2013


REMOVE FRONT WHEEL

REMOVE FRONT DISC BRAKE CYLINDER ASSEMBLY LH

  1. F043120
    Using a union nut wrench, disconnect the brake tube from the disc brake cylinder assembly.

    HINT:
    Use a container to catch brake fluid as it drains out.

  1. F043121
    Remove the 2 bolts and disc brake cylinder assembly.


REMOVE FRONT DISC

  1. C215913E01
    Place matchmarks on the disc and axle hub if planning to reuse the disc.
    Text in Illustration 
    *1
    Matchmark

  1. Remove the front disc.


REMOVE FRONT AXLE HUB GREASE CAP
  1. Using a screwdriver and hammer, remove the front axle hub grease cap.

    NOTICE:
    Do not damage the axle hub.


INSPECT FRONT AXLE HUB BEARING LOOSENESS

  1. C098703
    Using a dial indicator, measure the looseness near the center of the axle hub.

    Maximum looseness:
    0.05 mm (0.00197 in.)

    NOTICE:
    Make sure that the dial indicator is set at a right angle to the measurement surface.

    If the looseness is more than the maximum, replace the axle hub.


INSPECT FRONT AXLE HUB RUNOUT

  1. C098704
    Using a dial indicator, measure the runout on the surface of the axle hub outside the hub bolts.

    Maximum runout:
    0.08 mm (0.00315 in.)

    NOTICE:
    Make sure that the dial indicator is set at a right angle to the measurement surface.

    If the runout is more than the maximum, replace the axle hub.


INSTALL FRONT AXLE HUB GREASE CAP
  1. Install a new axle hub grease cap.

    NOTICE:
    Make sure the grease cap is securely installed to the axle hub.


INSTALL FRONT DISC
  1. Align the matchmarks and install the front disc.

    HINT:
    When replacing the disc with a new one, select the installation position where the disc has the smallest runout.


INSTALL DISC BRAKE CYLINDER ASSEMBLY LH
  1. Install the disc brake cylinder assembly with the 2 bolts.

    Torque:
    123 N*m{ 1254 kgf*cm , 91 ft.*lbf }

  1. Using a union nut wrench, connect the brake tube to the disc brake cylinder assembly.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (Click here).


INSTALL FRONT WHEEL

Torque:
112 N*m{ 1142 kgf*cm , 83 ft.*lbf }

← COMPONENTS (from Aug 2013)REMOVAL (from Aug 2013) →