2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

Air Conditioning Control Panel Circuit

Circuit diagnosis · Vehicles built Aug 2013 – Jul 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

This circuit consists of the integration control and panel assembly and air conditioning amplifier assembly. When the integration control and panel assembly is operated, signals are transmitted to the air conditioning amplifier assembly through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate when the integration control and panel assembly is operated.

WIRING DIAGRAM

E198323E02

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL AND PANEL - AIR CONDITIONING AMPLIFIER)
  1. Disconnect the G25 amplifier connector.

  1. Disconnect the G23 panel connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G23-3 (LIN1) - G25-37 (LIN1)
    Always
    Below 1 Ω
    G23-3 (LIN1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL AND PANEL - BATTERY AND BODY GROUND)

  1. E196918E04
    Disconnect the G23 panel connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    G23-1 (+B) - G23-4 (GND)
    Always
    11 to 14 V
    G23-5 (IG) - G23-4 (GND)
    Ignition switch off
    Below 1 V
    G23-5 (IG) - G23-4 (GND)
    Ignition switch ON
    11 to 14 V
    G23-6 (ACC) - G23-4 (GND)
    Ignition switch ACC
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G23-4 (GND) - Body ground
    Always
    Below 1 Ω

Text in Illustration 
*a
Front view of wire harness connector
(to Integration Control and Panel Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. REPLACE INTEGRATION CONTROL AND PANEL ASSEMBLY
  1. Replace the integration control and panel assembly with a new or normally functioning one (Click here).

  1. Operate the integration control and panel assembly to check that it functions properly.

    OK:
    Integration control and panel assembly operates normally.



NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

END (INTEGRATION CONTROL AND PANEL ASSEMBLY IS FAULTY)


← U0100 Lost Communication with ECM (+ U0142, U0155) (from Aug 2014)Air Conditioning Control Panel Circuit (from Aug 2014) →