This circuit consists of the integration control and panel assembly and air conditioning amplifier assembly. When the integration control and panel assembly is operated, signals are transmitted to the air conditioning amplifier assembly through the LIN communication system. If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate when the integration control and panel assembly is operated.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
1. CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL AND PANEL - AIR CONDITIONING AMPLIFIER)
Disconnect the G25 amplifier connector.
Disconnect the G23 panel connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
G23-3 (LIN1) - G25-37 (LIN1)
Always
Below 1 Ω
G23-3 (LIN1) - Body ground
Always
10 kΩ or higher
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
2. CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL AND PANEL - BATTERY AND BODY GROUND)
Disconnect the G23 panel connector.
Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection
Switch Condition
Specified Condition
G23-1 (+B) - G23-4 (GND)
Always
11 to 14 V
G23-5 (IG) - G23-4 (GND)
Ignition switch off
Below 1 V
G23-5 (IG) - G23-4 (GND)
Ignition switch ON
11 to 14 V
G23-6 (ACC) - G23-4 (GND)
Ignition switch ACC
11 to 14 V
Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
Specified Condition
G23-4 (GND) - Body ground
Always
Below 1 Ω
Text in Illustration
*a
Front view of wire harness connector (to Integration Control and Panel Assembly)
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
3. REPLACE INTEGRATION CONTROL AND PANEL ASSEMBLY
Replace the integration control and panel assembly with a new or normally functioning one (Click here).
Operate the integration control and panel assembly to check that it functions properly.
OK:
Integration control and panel assembly operates normally.
NG
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK
END (INTEGRATION CONTROL AND PANEL ASSEMBLY IS FAULTY)