2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE REAR SIDE NO. 4 AIR DUCT (w/ Rear Air Duct)

  1. B236606
    Remove the 3 screws and duct.


2. REMOVE REAR AIR MIX DAMPER SERVO SUB-ASSEMBLY

  1. B236611
    Disconnect the connector.

  1. Remove the 2 screws and damper servo.


3. REMOVE COOLER BRACKET

  1. B240509
    Remove the 4 screws and bracket.


4. REMOVE REAR MODE DAMPER SERVO SUB-ASSEMBLY

  1. B236613
    Disconnect the connector.

  1. Remove the 2 screws and damper servo.

    NOTICE:
    After removing the damper servo, do not move the gear of the servo unit.


5. REMOVE AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY

  1. B236607
    Remove the packing.

  1. B236608
    Detach the 3 claws and remove the cover.

  1. Remove the bolt and 2 screws.

  1. Using pliers, grip the claws of the clips and slide the 2 clips.

  1. Detach the clamp.

  1. Disconnect the drain hose.

  1. Remove the air conditioning tube and accessory assembly.

  1. Remove the 2 O-rings from the air conditioning tube and accessory assembly.


6. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY

  1. B236614
    Remove the screw.

  1. Detach the claw and open the heater clamp.

  1. B236615
    Remove the heater radiator.

  1. B236616
    Detach the 2 claws and remove the heater clamp.


7. REMOVE HEATER BRACKET

  1. B236617
    Remove the 3 screws and bracket.


8. REMOVE REAR BLOWER WITH FAN MOTOR SUB-ASSEMBLY

  1. B236618
    Remove the 3 screws and rear blower with fan motor.


9. REMOVE BLOWER MOTOR CONTROLLER

  1. B236619
    Remove the 2 screws and blower motor controller.


10. REMOVE REAR COOLING UNIT EXPANSION VALVE

  1. B236610
    Detach the 2 clamps.

  1. B236609
    Detach the 3 clamps and disconnect the air conditioning wiring harness from the rear cooling unit case.

  1. B236620
    Remove the 12 screws and rear cooling unit case LH.

  1. B236621
    Using a 4 mm hexagon wrench, remove the 2 hexagon bolts.

  1. B236622
    Remove the expansion valve.


11. REMOVE REAR EVAPORATOR SUB-ASSEMBLY

  1. B236623
    Remove the evaporator from the rear cooling unit case RH.

  1. E131047
    Remove the 2 O-rings from the evaporator.


12. REMOVE REAR EVAPORATOR TEMPERATURE SENSOR

  1. B236625
    Move the tip of the sensor in the direction indicated by the arrow in the illustration to remove it from the bracket plate.

  1. Detach the 2 claws and remove the sensor.


13. REMOVE AIR CONDITIONING HARNESS ASSEMBLY
← REMOVAL (from Aug 2014)REASSEMBLY (from Aug 2013) →