2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Aug 2013


1. REMOVE UPPER RADIATOR SUPPORT SEAL
  1. Remove the 13 clips and upper radiator support seal.


2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start the engine.

  1. Operate the cooler compressor under the conditions shown below:

    Item
    Condition
    Engine Speed
    Idling
    Operating Time
    3 minutes or more
    A/C Switch Status
    On
    Blower Switch Status
    HI
    Set Temperature
    MAX COOL
    This causes most of the compressor oil from the various components of the A/C system to collect in the A/C compressor.

    NOTICE:
    It is not necessary to operate the cooler compressor if the A/C does not operate because of compressor lock, etc.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.

    HINT:
    Use the refrigerant recovery unit in accordance with the manufacturer's instruction manual.


3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

  1. A224304
    Disconnect the sensor connector.

  1. Detach the wire harness clamp.

  1. Loosen the hose clamp and remove the resonator with air cleaner cap.

  1. A226728
    Detach the 4 hook clamps, and then remove the air cleaner cap and resonator with air cleaner cap.


4. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

  1. A224627
    Remove the 3 bolts and air cleaner case.


6. REMOVE COOLER COMPRESSOR V BELT

  1. A074095E03
    Loosen nut and adjusting bolt, and remove the V belt.
    Text in Illustration 
    *1
    Adjusting Bolt


7. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY

  1. E195756E01
    Remove the bolt and disconnect the discharge hose from the compressor.
    Text in Illustration 
    *A
    for Type A
    *B
    for Type B

  1. Remove the O-ring from the discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.


8. DISCONNECT SUCTION HOSE SUB-ASSEMBLY

  1. E195757E01
    Remove the bolt and disconnect the suction hose from the compressor.
    Text in Illustration 
    *A
    for Type A
    *B
    for Type B

  1. Remove the O-ring from the suction hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.


9. REMOVE COOLER COMPRESSOR ASSEMBLY
  1. Disconnect the connector.

  1. E195758
    Remove the 6 bolts, idle pulley bracket and cooler compressor assembly.

← COMPONENTS (from Aug 2013)DISASSEMBLY (from Aug 2013) →