2013-2015 Land Cruiser Prado · Service Manual Vehicle Interior

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2013


1. REMOVE COOLER BRACKET

E195759
  1. Detach the clamp.

  1. Remove the screw and cooler bracket.


2. REMOVE MAGNET CLUTCH ASSEMBLY

E195760E01
  1. Clamp the cooler compressor in a vise.

  1. Using SST, hold the magnet clutch hub.

    SST
    09985-00270  

  1. Remove the bolt, magnet clutch hub and magnet clutch washer.

    HINT:
    There is no set number of magnet clutch washers since they are used for adjusting.

  1. I104018
    Using a snap ring expander, remove the snap ring and magnet clutch rotor.

    NOTICE:
    Do not damage the seal cover of the bearing when removing the snap ring.

  1. Disconnect the connector.

  1. I104019
    Using a snap ring expander, remove the snap ring and magnet clutch stator.

← REMOVAL (from Aug 2013)INSPECTION (from Aug 2013) →