2013-2015 Land Cruiser Prado · Service Manual Suspension

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

HINT:
*: Use the intelligent tester.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
      NEXT

      3.INSPECT BATTERY VOLTAGE

        Standard voltage:
        11 to 14 V

        If the voltage is below 11 V, recharge or replace the battery before proceeding.
      NEXT

      4.CHECK AND CLEAR DTC*
      1. Check if any DTCs are output (Click here).

        HINT:
        The suspension control ECU of this system is connected to CAN communication system. Therefore, before starting troubleshooting, be sure to check that there is no trouble in CAN communication system (for LHD: Click here, for RHD: Click here).

        Result 
        Result
        Proceed to
        CAN DTC not output
        A
        CAN DTC output
        B


      B.
      A

      5.CHECK AND CLEAR DTC*
      1. Check for DTCs (Click here).

      NEXT

      6.PROBLEM SYMPTOM CONFIRMATION
        Result 
        Result
        Proceed to
        Symptom does not occur
        A
        Symptom occurs
        B

      B.
      A

      7.SYMPTOM SIMULATION
        NEXT

        8.CHECK DTC*
        1. Check for DTCs (Click here).

          Result 
          Result
          Proceed to
          DTC not output
          A
          DTC output
          B


        B.
        A

        9.PROBLEM SYMPTOMS TABLE
        1. Refer to the Problem Symptoms Table (Click here).

        NEXT

        10.DTC CHART
        1. Refer to the Diagnostic Trouble Code Chart (Click here).

        NEXT

        11.CIRCUIT INSPECTION*
          NEXT

          12.IDENTIFICATION OF PROBLEM
            NEXT

            13.REPAIR OR REPLACE
              NEXT

              14.CONFIRMATION TEST
                NEXT

                ← HOW TO PROCEED WITH TROUBLESHOOTING (Aug 2013 – Jul 2014)REGISTRATION (from Aug 2013) →