PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built from Aug 2014
Versions by build date: Aug 2013 – Jul 2014 from Aug 2014
- HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
| Symptom |
Suspected Area |
See page |
| Suspension control ECU does not operate |
Harness or connector (power source of suspension control ECU) |
Click here
|
| Suspension control ECU |
Click here
|
|
| Air suspension system DTC cannot be output (when using intelligent tester) |
CAN communication system (for LHD) |
Click here
|
| CAN communication system (for RHD) |
Click here
|
|
| Harness or connector (power source of suspension control ECU) |
Click here
|
|
| Suspension control ECU |
Click here
|
|
| Air suspension system DTC cannot be output (when not using intelligent tester) |
CAN communication system (for LHD) |
Click here
|
| CAN communication system (for RHD) |
Click here
|
|
| Harness or connector (power source of suspension control ECU) |
Click here
|
|
| Suspension control ECU |
Click here
|
|
| Combination meter assembly |
Click here
|
|
| Height control indicator does not come on |
CAN communication system (for LHD) |
Click here
|
| CAN communication system (for RHD) |
Click here
|
|
| Combination meter assembly |
Click here
|
|
| Harness or connector (power source of suspension control ECU) |
Click here
|
|
| Suspension control ECU |
Click here
|
|
| Height control indicator does not change even though vehicle height modes are switched using height control switch |
Check test mode DTC (height control switch signal check) |
Click here
|
| Suspension control relay (AIR SUS relay) |
- |
|
| Compressor motor |
Click here
|
|
| Harness or connector (power source of compressor motor) |
Click here
|
|
| Continuous electric current to height control |
Click here
|
|
| Suspension control ECU |
Click here
|
|
| Height control cannot be disabled using height control OFF switch |
Check test mode DTC (height control OFF switch signal check) |
Click here
|
| Suspension control ECU |
Click here
|
|
| Vehicle is not level |
Air leakage |
Click here
|
| Adjust height control sensor link |
Click here
|
|
| Height control sensor |
Click here
|
|
| Suspension control ECU |
Click here
|
|
| Warning message is shown on multi-information display even though DTC is not output |
Connect of the connector |
- |
| CAN communication system (for LHD) |
Click here
|
|
| CAN communication system (for RHD) |
Click here
|
|
| Harness or connector (power source of suspension control ECU) |
Click here
|
|
| Combination meter assembly |
Click here
|
|
| Suspension control ECU |
Click here
|