2013-2015 Land Cruiser Prado · Service Manual Suspension

U0100/71 Lost Communication with ECM/PCM "A"

Diagnostic trouble codes · Vehicles built Aug 2013 – Jul 2014

Also covers:

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

DTC Code
DTC Detection Condition
Trouble Area
U0100/71
While driving at 30 km/h (19 mph), the ECM informs of a CAN communication stop for 3 seconds or more.
CAN communication system
U0114/71
The four wheel drive control ECU informs of a CAN communication stop for 3 seconds or more.
U0122/71
The skid control ECU informs of a CAN communication stop for 3 seconds or more.
U0124/71
The yaw rate and acceleration sensor informs of a CAN communication stop for 3 seconds or more.
U0126/71
The steering angle sensor informs of a CAN communication stop for 3 seconds or more.
U0140/71
The main body ECU informs of a CAN communication stop for 10 seconds or more.
When DTCs indicating a CAN communication system malfunction are output, repair CAN communication system first.

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Perform a road test.

  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output (for LHD with Entry and Start System)
    B
    DTC is output (for LHD without Entry and Start System)
    C
    DTC is output (for RHD with Entry and Start System)
    D
    DTC is output (for RHD without Entry and Start System)
    E

    HINT:
    If a CAN communication malfunction DTC and a related sensor malfunction DTC are output at the same time, the CAN communication malfunction must be repaired before troubleshooting the sensor malfunction DTC.



B
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)

C
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)

D
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)

E
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)


← C1794/94 Height Control OFF Switch Circuit (Test Mode DTC) (from Aug 2014)U0100/71 Lost Communication with ECM/PCM "A" (+ 5 more codes) (from Aug 2014) →