INSPECTION
Inspection · Vehicles built from Aug 2013
| INSPECT LEVEL WARNING SWITCH ASSEMBLY |
- HINT:
- The following check should be performed with the windshield washer motor and pump assembly installed to the windshield washer jar assembly.
Fill the windshield washer jar assembly with washer fluid.
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Condition
Specified Condition
1 (S) - 2 (E)
Fluid volume is more than 750 cc (45.7 cu.in.)
10 kΩ or higher
1 (S) - 2 (E)
Fluid volume is less than 550 cc (33.5 cu.in.)
Below 1 Ω
- HINT:
- When the fluid volume is between 550 and 750 cc (33.5 and 45.7 cu.in.), the level warning switch assembly may be on or off.
Text in Illustration *a
Component without harness connected
(Level Warning Switch Assembly)
