2013-2015 Land Cruiser Prado · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014


1. REMOVE UPPER RADIATOR SUPPORT SEAL
  1. Remove the 13 clips and upper radiator support seal.


2. REMOVE RADIATOR GRILLE

B357908E01
  1. Put protective tape around the radiator grille.

  1. Remove the 4 screws.

  1. Detach the 8 claws and remove the radiator grille.

    Text in Illustration 
    *1
    Protective Tape


3. REMOVE FRONT BUMPER COVER

  1. B353268
    Remove the 2 screws.

    HINT:
    Use the same procedure for the screws on the other side.

  1. B353353E01
    Remove the 2 screws.
    Text in Illustration 
    *1
    Screw
    *2
    Bolt A
    *3
    Bolt B

  1. Remove the 2 bolts labeled A and 2 bolts labeled B.

  1. B353270E01
    Put protective tape around the front bumper cover.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the 4 clips.

  1. Detach the 16 claws and remove the front bumper cover.

    NOTICE:
    Do not hold the middle of the front bumper cover, as it may become reformed.

  1. w/ TOYOTA Parking Assist-sensor System, w/ Fog Light:
    Disconnect the 3 connectors.

  1. w/ TOYOTA Parking Assist-sensor System, w/o Fog Light:
    Disconnect the connector.

  1. w/o TOYOTA Parking Assist-sensor System, w/ Fog Light:
    Disconnect the 2 connectors.

  1. w/ Headlight Cleaner System:
    Disconnect the No. 1 headlight cleaner hose.


4. REMOVE WASHER INLET SUB-ASSEMBLY

  1. E197530
    Detach the claw and remove the washer inlet sub-assembly.


5. REMOVE WINDSHIELD WASHER JAR ASSEMBLY
(Click here)

6. REMOVE WASHER JAR PROTECTOR

  1. E281674
    Detach the 2 claws and remove the washer jar protector.


7. REMOVE LEVEL WARNING SWITCH ASSEMBLY

  1. E281675
    Disconnect the connector.

  1. Remove the level warning switch assembly from the packing of the windshield washer jar assembly.

← REMOVAL (Aug 2013 – Jul 2014)INSPECTION (from Aug 2013) →